Scubapro 500 crystal gasket
Scubapro 500 crystal gasket
Need a new gasket as the old one failed the pressure test. Watch is a scubapro 500 . Have a Submarex with the same kind of gasket that i would like to change the gasket on also. The old gasket was lite glue and popped out of the case.
Anyone now where to start looking. It's looks a little like a Seiko 6309 gasket but smaller. And is held down with a screwed retaining ring . Special shaped crystal.
Can you help me out a little?
First time here so be nice
Anyone now where to start looking. It's looks a little like a Seiko 6309 gasket but smaller. And is held down with a screwed retaining ring . Special shaped crystal.
Can you help me out a little?
First time here so be nice
Re: Scubapro 500 crystal gasket
Jack installed all new gaskets on my Scubapro a couple years ago so I'm sure he can help you. Good luck!
Re: Scubapro 500 crystal gasket
Tried contact Jack at IWW but he is not answering. A friend of mine tried also. It's his watch btw. Anyone now how i can get in touch with him or IWW.
Re: Scubapro 500 crystal gasket
Here is his contact info also has email and phone number he could be on Vacation so not picking up the phone. Just send a email and wait and try next week to call again. I never had a problem the few times I talked to him on the phone.
http://internationalwatchworks.com/contact/
http://internationalwatchworks.com/contact/
Re: Scubapro 500 crystal gasket
Will do
Re: Scubapro 500 crystal gasket
Now i at least now how a gasket look. It's in fact 2 gasket. One sits in the bottom and looks about the same as the Seiko gasket. And then there is a flat gasket sitting on the top of the crystal so that it sits in the middle of the case.
- apollowatches
- Posts: 13
- Joined: Sat Sep 09, 2017 5:54 am
- Name: Apollo
- Contact:
Re: Scubapro 500 crystal gasket
Tried contact Jack!
Re: Scubapro 500 crystal gasket
Yepp. He doesn't answer my mail. Not sure why? He said he wanted the case sent to him. I said i do it myself as i have the know how to do it. I asked politely if i could buy a couple of gasket instead. Then he didn't answer. Fine with me. Would cost me to much to send to USA and back just for a gasket or two.
Figured it out anyway.
Who is online
Users browsing this forum: No registered users and 80 guests